There is a hidden menu inside your Nokia phone. If you want to activate it, you'll have to re-program some chips inside of your phone.
Check your software version. You can only continue if you have v4.33, v4.73 or v5.24.
Take apart the phone.
De-solder the EEPROM (ATMEL AT 24C64).
Read out the data with an EEPROM programmer and save it to a file (Backup).
If you have v.33 or v4.73, change the address "03B8" from "00" to "FF".
If you have v5.24 then change the address "0378" from "00" to "FF".
Write the new data to the EEPROM and solder it back to the phone,
Power on your phone and you should have "Netmonitor" enabled.
The Network Monitor gives you the following information.
Carrier number
MS RX Level in DBM
Received signal quality
MS TX power level
C1 (Path loss criterion, used for cell selection and reselection). The range is -99 to 99.
RTL (Radio link timeout).
Timeslot
Indication of the transmitter status
Information on the Network parameters.
TMSI (Temporary Mobile Subscriber Identity).
Cell identification (Cell ID, Number of cells being used).
MCC (Mobile country code)
MCN (Mobile network code)
LAC (Location area code)
Ciphering (On/Off)
Hopping (On/Off)
DTX (On/Off)
Discard cell barred information
MMC Trick
In order to swap the memory of two Nokia phones, but with memory cards wherein one phone has Reduced sized multimedia card(RS-MMC) compatibility and the other phone has Multimedia card (MMC) compatibility. There are 5 steps which will prove to be of great help. Follow the instructions below.
1. Remove the RS-MMC card,
2. Remove the MMC card
3. Now hold the RS-MMC card in hand
4. Simply insert it in the slot meant for the MMC card in such a position where all the pins connect with the pins on the slot of your MMC Compatible phone,
5. Fix the battery and switch on the phone.
Now the data readily available on the RS-MMC can be used.
RS-MMC Cards (Reduced Sized Multi-Media Cards)
MMC Cards (Multi-Media Cards)
Hidden Trick : NETWORK MONITOR
Monday, November 14, 2011
Posted by
Amisauv
at
5:06 AM
Subscribe to:
Post Comments (Atom)
0 comments:
Post a Comment